# Testing the robustness of a sensorless drive spinup configuration using Yakut

**URL:** <https://forum.opencyphal.org/t/testing-the-robustness-of-a-sensorless-drive-spinup-configuration-using-yakut/1716>\
**Category:** CLI tools (Cynic/Yakut)\
**Created:** [July 19, 2022, 12:28pm UTC](https://forum.opencyphal.org/t/testing-the-robustness-of-a-sensorless-drive-spinup-configuration-using-yakut/1716 "2022-07-19T12:28:21Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![pavel.kirienko](https://forum.opencyphal.org/user_avatar/forum.opencyphal.org/pavel.kirienko/32/9_2.png) [@pavel.kirienko](https://forum.opencyphal.org/u/pavel.kirienko)\
**Post date:** [July 19, 2022, 12:28pm UTC](https://forum.opencyphal.org/t/testing-the-robustness-of-a-sensorless-drive-spinup-configuration-using-yakut/1716/1 "2022-07-19T12:28:21Z")

</div>

First, set the setpoint timeout to a large value, say, 5 seconds (this one depends on the type of the ESC used) (125 is the node-ID of the ESC):

```auto
y r 125 mns.deadman_timeout 5.0
y r 125 mns.setpoint_index 0
y cmd 125 restart

```

Then publish some setpoint every 8 seconds to let the motor restart repeatedly:

```auto
y -v pub -T 8.0 10:reg.udral.service.common.readiness 3 25:zubax.telega.setpoint.raw9x6 '[100, 0, 0, 0, 0, 0]'

```

The motor will be stopped automatically in 5 seconds from the last setpoint due to the expiration of the setpoint timeout. After 3 seconds of idling, it will be restarted again by the next setpoint message.

Monitor the status in a separate terminal:

```auto
y sub 10:reg.udral.service.common.readiness 130:reg.udral.service.actuator.common.status 100:reg.udral.service.actuator.common.feedback

```
